Install rear window jeep wrangler




















MagMan , Aug 21, So it sounds like your having an issue getting the zipper to zip around the sharp corners where the zipper binds up. So if this is correct I might suggest spraying the teeth with silicone spray. That is what I use to assist with the zipper operation.

Also Lemon Pledge works great with cleaning the clear plastic. JKBob 25 , Aug 21, When we bought our '04 TJ, the back window zippers had separated near the corners. Took me a whole day to walk them back and get the window out without damaging the zippers. At that point, I used candle wax to lube each side of the zippers, then reinstalled it.

Yes, the corners are a PITA. What I found was when trying to get the zippers past the corners, use one hand to pull on the outside pull tab while reaching in the gap with your other hand and simultaneously pulling on the inside tab. This helps to distribute force evenly to both sides of the zipper which makes it easier to get around the corners.

MikenMel , Dec 7, JKBob 25 and aggrex like this. Welcome MikenMel Works much better in the heat than in the cold. You can also use paraffin wax in the zipper teeth to lube it without it being greasy. Hammer12b , Dec 11, On my CJ, after unjipping the rear window, I have installed snaps to the sport bar that I connect the rear window snaps to. That way it protects it from any more scratches than it already has, especially when there is a lot of trail dirt on it.

Jim Beam , Dec 11, With this, you can protect the passengers from the harmful ultraviolet sun rays while having a tint for privacy concerns. After replacing the old one with the new one, now, it is important to know how to take well care of the windows and maintain them. The rear or side window of a Jeep Wrangler Hardtop does not need a drill to remove the glass. In fact, a knife is only required to cut through the molding cleanly. By carefully following instructions, you cannot tamper or ruin the paint.

If you decide to have a third party replace it, make sure to watch over them if they do so. Other windows are non-defrosting. Although there are non-defrosting options available in the market, buying defrosting windows should be considered, especially if your environment easily fogs up car windows. Tempered glass is a highly durable material that prevents complete shattering. Instead of the usual breaking of glass into a million pieces, tempered glass only shatters into miniscule pebble-sized pieces and can barely puncture you unless with great pressure or force applied.

This decision is all up to you! You can, but you would have to guarantee that it would fit well with your Jeep Wrangler model as some aftermarket replacements have a loose fit or do not fit the window frame at all. When finding the best replacement, have a list of all your options before narrowing it down to the one that suits you best. Mopar is the trusted customer care and car service brand for the leading car brands like Dodge, Chrysler, Ram, and Jeep.

This instruction video teaches how to flawlessly remove the rear window for recreational purposes or for replacement. Interested in adding window panels on the side?

Learn how to replace the side glass window in this instructional video by David Van Voris. He shows the process from unboxing his newly bought replacement to ensuring the newly installed window is secure. Your email address will not be published. Save my name, email, and website in this browser for the next time I comment.

There are many reasons you need to have a Jeep Wrangler Hardtop side window replaced. Most of these items can be found in online shopping stores that sell car accessories and parts. Knives Prepare a razor knife for cutting the molding and a cold, sharp knife for cutting the urethane. Grease pencil The pencil will be used for simple markings to remember which side goes where when installing the window.

Cleaning materials Have an ammonia-based cleaner, naphtha or a similar product, and two lint-free cloths that are dry and clean to be used when cleaning different parts of the window. Molding If your replacement does not have molding, secure one first before installing as it will not be possible to place the window without the molding. Primers The following are solvents you need to procure for installation: glass prep adhesion promoter, glass primer, and pinchweld primer.

Masking tape For safety precautions, this will be used to stabilize and hold the window in place in the end. Step By Step Guide to Jeep Wrangler Hardtop Rear Window Replacement Some window replacements already have instructions provided upon purchase, but if a manual is not included, a step-by-step guide is below to help.

Removing the window 1. Cut around the inside of the molding A razor knife will help you in this task. Removing the glass Now, with a cold knife, slice the urethane around the quarter glass. Installing the window 4.

Install the glass Get your replacement window and place it in the center of the opening. Verify the measurements and fit Check its fit all around, and use a grease pencil to make marks on the glass and top for alignment.

Clean the glass Afterward, take the glass away and use a lint-free cloth and ammonia-based cleaner to clean the inside. Prep the glass Place a molding around the glass with its butt weld being at the center of the bottom edge.

Next, do the same with the glass primer and do not wipe it, but let it dry for three minutes. Prep the fence Place pinchweld primer 15 mm wide around the whole fence, and let it dry for three minutes before applying a bead of urethane 10 mm diameter in the middle of the surface area of the glass fence.

Placing the window Align and position the glass with the grease markings on the fence and immediately, but carefully, install the window by pushing it inward until the molding sits perfectly on the hardtop.

Once it has cured, remove the tape and do a water test to ensure its fixation. Expect to have additional charges like labor fees when having it done by a third party. PRR Industries — Highlighted Features Back window glass is non-defrosting Tempered Glass High-quality rubber-sealed glass Fits perfectly on Jeep Wrangler Hard Tops Same green clear tint as original This Jeep Wrangler Hardtop side window replacement glass by PRR Industries is made with durable tempered glass and comes with a rubber seal molding around it to keep it tight, fit, stable, and protected.

Pros An identical quality to the original Easy installation Fits well with said models Cons Only fits models No instruction manual included Pros Easy installation Fits like a glove Fits models as described Cons Not compatible with aftermarket replacement frames Maintenance Tips to Help After replacing the old one with the new one, now, it is important to know how to take well care of the windows and maintain them.

Do not use bleach or household products as these have strong solvents that can destroy the hardtop itself and the window. This may deteriorate the film and material of the window, which would be a waste.

Use water and a mild cleanser to clean the car.



0コメント

  • 1000 / 1000